VenomPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

APPLICATION INFORMATION

Failure to follow directions and precautions on this label may result in crop injury, poor insect control and/or illegal residues. For best performance, always follow these directions:

• Apply Venom Insecticide when insect pest populations begin to build, but before populations reach economically damag- ing levels Check with your State and County Extension Service for availability of economic thresholds for pests controlled by Venom Insecticide

• Venom Insecticide is a selective insecticide which will typically have minimal impact on beneficial arthropods and its use is compatible with Integrated Pest Management (IPM) programs However, Venom Insecticide is toxic to bees exposed to direct treatment or to residue on blooming crops and weeds Do not apply Venom Insecticide or allow it to drift onto blooming plants if bees are foraging in the treated area

• Venom Insecticide is taken up into foliage after application However, thorough spray coverage is essential for optimal performance Apply Venom Insecticide in sufficient water to ensure good coverage

• Venom Insecticide will suppress some pests Suppression is defined as either inconsistent control (good to poor), or consis- tent control at a level below that generally considered accept- able for commercial control

Rotational Crops For crops other than cotton, cucurbits, fruiting vegetables, grapes, head & stem brassica, leafy vegetables and potato, observe a 120 day plant back interval

MIXING INSTRUCTIONS

Add 1/2 of the required amount of water to the mix tank With the agitator running, add the desired amount of Venom Insecticide to the tank Continue agitation while adding the remainder of the water Begin application of the solution after Venom Insecticide has completely dispersed into the mix water Maintain agitation until all of the mixture has been applied

Venom Insecticide plus Tank Mixtures Add 1/2 of the required amount of water to the mix tank Start the agitator before adding any tank mix partners Whenever possible add tank mix partners in this order: products packaged in water soluble packaging, wettable powders, wettable granules (dry flowables), liquid flowables, liquids, emulsifiable concentrates, surfactants and adjuvants Always allow each tank mix partner to become fully dispersed before adding the next product Pro- vide sufficient agitation while adding the remainder of the water Maintain agitation until all the mixture has been applied When using Venom Insecticide in tank mixtures, add all products in water soluble packaging to the tank before any other tank mix partner, including Venom Insecticide Allow the water soluble packaging to completely dissolve and the product(s) to completely disperse before adding any other tank mix partner to the tank If using Venom Insecticide in a tank mixture, observe all directions for use, crops/sites, use rates, dilution ratios, precautions and limitations which appear on the tank mix product label Do not exceed labeled dosage rate of any product in the tank mix Follow the most restrictive label precautions and limitations of any product in the tank mix Do not mix Venom Insecticide with any product whose label prohibits such mixing Tank mixtures or other applications of products referenced on this label are permitted only in those states in which the referenced products are labeled