Stacato 750 WGPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

For selective weed control in cereals, pastures, sugarcane, TT canola, and other crops, including vegetables.

GENERAL INSTRUCTIONS:

Stacato 750 WG Herbicide is non-corrosive to equipment, non-flammable and non-volatile. The degree of weed control and duration of effect will vary with the amount of herbicide applied, soil texture, rainfall and other conditions. Stacato 750 WG Herbicide is effective against a range of broadleaf weeds and some grasses. Stacato 750 WG Herbicide is absorbed by roots, shoots and leaves of weeds. If can therefore be applied before or after the weeds emerge depending upon the tolerance of the crop being treated. For recently introduced varieties DO NOT use Stacato 750 WG Herbicide unless it is ascertained that the variety to be treated shows sufficient tolerance to the treatment under local climatic conditions. Dense weed populations and multiple germinations (especially Wild radish) may require both a pre-emergent and post emergent herbicide treatment to give acceptable control. Stacato 750 WG Herbicide to be only one of those two treatments.

MIXING AND APPLICATION COMPATIBILITY

Stacato 750 WG Herbicide is compatible with the herbicides chlorsulfuron, metsulfuron, glyphosate, pendimethalin, propargite, Brodal Selective Herbicide and trifluralin 480. DO NOT apply wetting agents, spray oils or grass selective herbicides with Stacato 750WG Herbicide. As formulations of other manufacturer’s products are beyond the control of Sipcam, all mixtures should be tested prior to mixing commercial quantities. As changes in climatic conditions can alter the sensitivity of plants to mixtures of sprays, Sipcam cannot be responsible for the behaviour of such mixtures.

MIXING
General:
Stacato 750 WG Herbicide is a selective systemic herbicide that inhibits photosynthesis in target weeds. Stacato 750 WG Herbicide is to be mixed with water and applied as a spray. Before spraying calibrate equipment to determine the quantity of water necessary to uniformly cover the measured area to be treated. Partially fill the tank with water. Measure the amount of herbicide required for the area to be sprayed, adding this amount of Stacato 750 WG Herbicide to the spray tank with the agitation system engaged. Top up to the correct volume with water.