SentrallasPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

FOR SALE FOR USE ON SPRING WHEAT (INCLUDING DURUM), WINTER WHEAT, SPRING BARLEY AND OATS

PRODUCT DESCRIPTION:
DuPont Sentrallas HERBICIDE is recommended for selective post-emergent control or suppression of broadleaf weeds in spring wheat (including durum), winter wheat, spring barley and oats not underseeded to legumes or grasses. DuPont Sentrallas HERBICIDE contains two active ingredients formulated as an oil dispersion. DuPont Sentrallas HERBICIDE is to be mixed with water and applied as a uniform broadcast spray early postemergence to the crop, to the main flush of actively growing broadleaf weeds.
Warm, moist growing conditions promote active weed growth and enhance the activity of DuPont Sentrallas HERBICIDE by allowing maximum foliar uptake and contact activity. Weeds hardened off by cold weather or drought stress may not be adequately controlled or suppressed and regrowth may occur. For best results, ensure thorough spray coverage of target weeds. See "DIRECTIONS FOR USE" section of this label for complete use details.
Degree of control and duration of effect are dependent on weed sensitivity, weed size, crop competition, growing conditions at and following treatment, and spray coverage.

DIRECTIONS FOR USE:
Field Sprayer Application:
DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty. DO NOT apply with spray droplets smaller than the American Society of Agricultural Engineers (ASAE) medium classification. Boom height must be 60 cm or less above the crop or ground.
Aerial application:
DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty. DO NOT apply when wind speed is greater than 16 km/h at flying height at the site of application. DO NOT apply with spray droplets smaller than the American Society of Agricultural Engineers (ASAE) coarse classification. To reduce drift caused by turbulent wingtip vortices, the nozzle distribution along the spray boom length MUST NOT exceed 65% of the wing- or rotorspan.