Advise Max

Manufacturer
WinField
Category
Insecticides
Registered until
N/A
Registration number
42750-137-1381
Active materials
Links

DIRECTIONS FOR USE
Itis a violation of FederaLlaw to use t&is product in a mannerJnconsistentwith its labeling.
Do not apply this product in a way thaj will contact workers or other persons, either directly or through drift. Only protected handlers may be jn the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

APPLICATION DIRECTIONS
Do Not Apply IMIDACLOPRID 4L CTN In Enclosed Structures Such As Greenhouses Or Planthouses. IMIDACLOPRID 4L CTN must be applied as a directed or broadcast foliar spray. Thorough coverage of foliage is necessary without runoff for optimum insecticidal efficacy. Use adequate spray volumes, properly calibrated application equipment and spray adjuvant if necessary to obtain thorough coverage.
Failure to provide adequate coverage and retention of IMIDACLOPRID 4L CTN on leaves and fruit may result in loss of insect control or delay in onset of activity. IMIDACLOPRID 4L CTN may be applied with properly calibrated ground or aerial application equipment. Minimum specified spray volumes unless otherwise directed on crop specific application sections are 10 gallons/Acre by ground application and 5 gallons/Acre through aerial equipment. IMIDACLOPRID 4L CTN may also be applied by overhead chemigation (see additional CHEMIGATION DIRECTIONS FOR USE section below) if allowed in crop specific Application Instructions section.
IMIDACLOPRID 4L CTN use on crops grown for production of true seed intended for private or commercial planting is* typically restricted but may be allowed under State specific 24(c) labeling. Additional information on IMIDACLOPRID 4L CTN used for these crops and other questions may be obtained form the Cooperative Extension Service, PCAs, consultants or local Albaugh, Inc. representatives. ,
RESTRICTIONS: Do not apply more than 0.5 Ib active ingredient per acre, per crop year, regardless of formulation or method 'of application, unless specified within a crop-specific Application section for a given crop.

MIXING INSTRUCTIONS
1. Fill spray tank with 1/4 to 1/3 water volume to be used
2.Add IMIDACLOPRID 4L CTN
3. Add final amount of water maintaining agitation
4. Add any tank mix products in order listed below

Mixing Order for Tank Mixes
1. Wettable powder or Water Dispersible Granule products
2. Other Flowables
3. Emulsifiable Concentrates
Maintain agitation as each component is added and do not add next tank mix product until prior product is thoroughly mixed. If a fertilizer solution is added, use of a compatibility agent may be needed.
Maintain constant agitation during both mixing and application to ensure uniformity of spray mixture.
If applicator has no past experience with a particular tank mix then a standard compatibility test should be conducted. Mix intended tank'mix components in a clear one quart jar at approximate ratios and shake vigorously for 3-5 minutes. Allow to stand and observe any adverse reactions such as precipitate or separation that indicates incompatibility. 

Registered for culturesRate
Cotton0.9 - 1.8 fl oz
Soybeans1.35 fl oz