Imidacloprid 4L CTN

Registered until
Registration number

Do Not Apply IMIDACLOPRID 4L CTN In Enclosed Structures Such As Greenhouses Or Planthouses.
IMIDACLOPRID 4L CTN must be applied as a directed or broadcast foliar spray. Thorough coverage of foliage is necessary without runoff for optimum insecticidal efficacy. Use adequate spray volumes, properly calibrated application equipment and spray adjuvant if necessary to obtain thorough coverage.
Failure to provide adequate coverage and retention of IMIDACLOPRID 4L CTN on leaves and fruit may result in loss of insect control or delay in onset of activity. IMIDACLOPRID 4L CTN may be applied with properly calibrated ground or aerial application equipment. Minimum specified spray volumes unless otherwise directed on crop specific application sections are 10 gallons/Acre by ground application and 5 gallons/Acre through aerial equipment. IMIDACLOPRID 4L CTN may also be applied by overhead chemigation (see additional CHEMIGATION DIRECTIONS FOR USE section below) if allowed in crop specific Application Instructions section.
IMIDACLOPRID 4L CTN use on crops grown for production of true seed intended for private or commercial planting is typically restricted but may be allowed under State specific 24(c) labeling. Additional information on IMIDACLOPRID 4L CTN used for these crops and other questions may be obtained form the Cooperative Extension Service, PCAs, consultants or local Albaugh, Inc. representatives. 

RESTRICTIONS: Do not apply more than 0.5 Ib active ingredient per acre, per crop year, regardless of formulation or method 'of application, unless specified within a crop-specific Application section for a given crop.

1. Fill spray tank with 1/4 to 1/3 water volume to be used
3. Add final amount of water maintaining agitation
4. Add any tank mix products in order listed below

Mixing Order for Tank Mixes
1. Wettable powder or Water Dispersible Granule products
2. Other Flowables
3. Emulsifiable Concentrates
Maintain agitation as each component is added and do not add next tank mix product until prior product is thoroughly mixed. If a fertilizer solution is added, use of a compatibility agent may be needed. Maintain constant agitation during both mixing and application to ensure uniformity of spray mixture. If applicator has no past experience with a particular tank mix then a standard compatibility test should be conducted. Mix intended tank'mix components in a clear one quart jar at approximate ratios and shake vigorously for 3-5 minutes. Allow to stand and observe any adverse reactions such as precipitate or separation that indicates incompatibility.

Refer to DIRECTIONS FOR USE section before proceeding with chemigation application.

Types of Irrigation Systems
Chemigation applications of IMIDACLOPRID 4L CTN may be made to crops through overhead sprinkler chemigation systems if specified in crop-specific Application Instruction sections. Do not apply IMIDACLOPRID 4L CTN through any other type of irrigation system.

Water Volume
Make IMIDACLOPRID 4L CTN chemigation applications as concentrated as possible. Retention of IMIDACLOPRID 4L CTN on target site of insect infestation is necessary for optimum activity. Do not chemigate IMIDACLOPRID 4L CTN in water volumes exceeding 0.1 inch/Acre. Uniform Water Distribution and System Calibration The irrigation -system—must provide uniform distribution-of—treated—water- Crop injury, lack of effectiveness, or illegal pesticide residues in the crop can result from non-uniform distribution of treated water. The system must be calibrated to uniformly apply the rates specified. If you have questions about calibration, you should contact State Extension Service Specialists, equipment 'manufacturers or other experts.

Chemigation Monitoring
A person knowledgeable of the Chemigation system and responsible for its operation, or under the supervision of the responsible person, shall shut the system down and make necessary adjustments
should the need arise. 

Registered for cultures