Imidacloprid 75 WP AGPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

APPLICATION INSTRUCTIONS
Apply IMIDACLOPRID 75 WP AG as a directedtor broadcasrfoliarspfay7"Thl5rough coverage of foliage without runoff is required for maximum insecticidal efficacy. Use of adequate spray volumes and correctly calibrated application equipment is critical. Use'of a spray adjuvant may enhance thorough coverage.
Lack of adequate coverage and retention of IMIDACLOPRID 75 WP AG on foliage and fruit can delay or lessen insect control. IMIDACLOPRID 75 WP AG may be applied with ground or aerial application equipment that has been properly calibrated.
Minimum spray volumes (unless otherwise specified on crop sections) are:
• 10 gallons/Acre by ground application 
• 5 gallons/Acre through aerial equipment. 

IMIDACLOPRID 75 WP AG may also be applied by overhead chemigation (see CHEMIGATION DIRECTIONS FOR USE section below) if allowed in crop specific application section. IMIDACLOPRID 75 WP AG application to crops grown for production of true seed intended for private or commercial planting are not allowed unless permitted under State specific 24 (c) labeling. Additional information on IMIDACLOPRID 75 WP AG uses for these crops and other questions may be obtained from the Cooperative Extension Service, PCAs, consultants or local Albaugh representatives.

RESTRICTIONS:
• Do not exceed application of more than 0.5 Ibs. active ingredient per acre, per year, regardless of formulation or method of application, unless specified within a crop specific applications section for a given crop.

Mixing Instructions
1. Add a 50% of the required amount of water to the spray tank
2. Begin agitation
3. Add labeled rate of IMIDACLOPRID 75WP AG
4. Add balance of water needed.
Maintain sufficient agitation during both mixing and application. IMIDACLOPRID 75 WP AG may be tank mixed with other pesticides and/or fertilizer solutions. Refer to Compatibility Note below. When tank mixing IMIDACLOPRID 75 WP AG with other pesticides, prepare the tank mixture as recommended above and follow suggested Mixing Order below.

Mixing Order for Tank Mixes
1. Wettable powders
2. IMIDACLOPRID 75WP AG, or other flowables second,
3. Emulsifiable concentrates
Maintain good agitation as each pesticide is added. Do not add the next product until the previous is thoroughly mixed. If a fertilizer solution is added, a fertilizer pesticide compatibility agent may be needed. Maintain constant agitation during both mixing and application to ensure uniformity of spray mixture.

Compatibility Note
Unless the applicator has prior knowledge of the compatibility of the intended tank mixture, Albaugh recommends a small scale test by adding proportionate amounts of each ingredient in the appropriate order, to a clear pint or quart sized jar. Cap and shake for 5 minutes, then let set for 5 minutes. Any visual indication of poor mixing or formation of precipitates that cannot be easily re-dispersed indicates incompatibility and the mixture that should not be used.