LPI Metolachlor + Atrazine Herbicide

Manufacturer
Loveland Products
Category
Herbicides
Registered until
N/A
Registration number
34704-1072
Active materials
Links

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. ANY USE OF THIS PRODUCT IN AN AREA WHERE USE IS PROHIBITED IS A VIOLATION OF FEDERAL LAW. Before using this product, you must consult the Atrazine Watershed Information Center (AWIC) to determine whether the use of this product is prohibited in your watershed. AWIC can be accessed through [www.atrazinewatershed.info], or [1-866-365-3014]. If use of this product is prohibited in your watershed, you may return this product to your point of purchase or contact Loveland Products, Inc. for a refund.
Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation. 

USE INFORMATION
This product is a selective herbicide that may be used before planting, before or after emergence (see directions) for control of most annual grasses and broadleaf weeds in corn (all types). This product may be tank mixed with other herbicides specified on this label for weed control in conventional, minimum-till, and no-till corn.

Note: Tank mixtures are permitted only in those states where the tank mix partner is registered. Refer to and follow the label for each tank mix product used for precautionary statements, directions for use, geographic and other restrictions. Following many years of continuous use of atrazine (one of the ingredients in thisproduct), and products chemically related to atrazine, biotypes of some of the weeds listed on this label which are controlled by the atrazine component have been reported to develop resistance to this-and chemically related herbicides. Where this is known or suspected, and weeds controlled by this product are expected to be present along with resistant biotypes, we recommend the use of this product in combination or in sequence with registered herbicides, which do not contain triazines. Consult with your State Agricultural Extension Service for specific recommendations.
When tank-mixing or sequentially applying atrazine and/or simazine or products containing atrazine and/or simazine to corn, do not exceed a combined application rate of 2.0 pounds combined active ingredient per acre for any single application, and the total pounds of atrazine and/or simazine applied (Ibs/A) must not exceed 2.5 pounds combined active ingredient per year.
This product alone or in tank mixture with atrazine, isoxaflutole (Balance), metolachlor (Stalwart C), or simazine (Sim-Trol) may be applied early preplant, preplant surface, preplant incorporated, or preemergence in water or fluid fertilizer. Apply postemergence treatments of this product using water only as the carrier. This product may be applied in tank mix combination with paraquat (Gramoxone Xtra), 2,4-D +glyphosate (Landmaster BW), or glyphosate (Makaze) with or without the above herbicides preplant surface or preemergence. This product may be applied in water by aircraft. Applications in fluid fertilizer should be only by ground equipment. To avoid spray drift, do not apply under windy conditions. Avoid spray overlap, as crop injury may result.
Do not apply this product through any type of irrigation system.
Do not apply this product in a greenhouse.
Do not graze or feed forage from treated areas for 60 days following application for corn (all types) (60-day PHI). Post-emergent applications to corn must be made before the crop reaches 12 inches in height.
Do not apply under conditions, which favor runoff or wind erosion of soil containing this product to nontarget areas.

To prevent off-site movement due to runoff or wind erosion:
1. Avoid treating powdery dry or light sand soils when conditions are favorable for wind erosion. Under these conditions, the soil surface should first be settled by rainfall or irrigation.
2. Do not apply to impervious substrates, such as paved or highly compacted surfaces.
3. Do not use tailwater from the first flood or furrow irrigation of treated fields to treat nontarget crops, unless at least 1/2 inch of rainfall has occurred between application and the first irrigation.
Where reference is made to weeds partially controlled, partial control can either mean erratic control from good to poor, or consistent control at a level below that generally considered acceptable for commercial weed control.
Dry weather following preemergence application of this product or a tank mixture may reduce effectiveness. Cultivate if weeds develop. Thoroughly clean sprayer or other application device before using. Dispose of cleaningsolution in a responsible manner. Do not use a sprayer or applicator contaminated with other materials, or crop damage or sprayer clogging of the application device may occur.

Registered for cultures
Corn