IsacopPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS

Application:

DILUTE SPRAYING (Tree and Vine crops only):

1. Use a sprayer designed for high water volumes up to the point of runoff, matched to the crop.
2. Set up the sprayer to achieve even coverage throughout the crop canopy.
3. Apply sufficient water to cover the crop to the point of run-off, avoiding excessive run-off.
4. Determine the required water volume through tests, industry guidelines, or expert advice.
5. Add the specified amount of product per 100 L of water according to the Directions for Use table.
6. Spray to the point of run-off, adjusting dilute spray volume and sprayer settings as the crop grows.

CONCENTRATE SPRAYING (Tree and Vine crops only):

1. Use a sprayer designed for concentrate spraying, matched to the crop.
2. Set up and operate the sprayer for even coverage throughout the crop canopy using the chosen water volume.
3. Determine an appropriate dilute spray volume (See Dilute Spraying above) for the crop canopy.
4. Calculate the mixing rate for concentrate spraying:
   • Dilute spray volume (e.g., 1500 L/ha) ÷ Concentrate spray volume (e.g., 500 L/ha) = Concentration factor (e.g., 3)
   • If the dilute label rate is 10 mL/100 L, then the concentrate rate is 3 x 10, i.e., 30 mL/100 L of concentrate spray.
5. Adjust spraying parameters as the crop grows.
6. For further information on concentrate spraying, refer to industry guidelines, competency training, and best practices.

GENERAL INSTRUCTIONS (ALL CROPS)

MIXING AND APPLICATION:

• Pre-mix ISACOP 500WP Fungicide with a small amount of water before adding to the spray vat.
• Agitate before and during spraying.
• Climatic conditions during and after application may affect efficacy and plant tolerance.
• Do not apply during abnormally hot, cold, and slow drying conditions.
• Ensure correct strength and timing for optimal results.

COMPATIBILITY:

• When recommended to add summer oil to ISACOP Fungicide, mix the oil at label rates with an equal volume of water before adding to the spray tank.
• Do not mix ISACOP Fungicide with lime sulphur.

Resistance Warning:

• ISACOP 500WP Fungicide is a Group M1 fungicide with multi-site activity.
• Fungicide resistance management is crucial to prevent the dominance of resistant fungi.
• Use ISACOP 500WP judiciously, as repeated use may lead to resistance.
• ISAGRO Australia Ltd accepts no liability for losses resulting from the failure to control resistant fungi.