Titan Chlorpyrifos 500Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS – For use as a Termiticide:

MIXING:

• Half fill the spray tank with water (or creosote where applicable).

• Add the required amount of TITAN CHLORPYRIFOS 500.

• Add the remaining water (or creosote) with an agitator running.

• If using a knapsack sprayer, gently shake before using.

• Only mix sufficient chemical for each specific application.

CLEANING SPRAY EQUIPMENT:

• After using TITAN CHLORPYRIFOS 500, empty the spray equipment completely and drain the whole system.

• Thoroughly wash inside the tank using a pressure hose and drain.

• To wash the system, quarter fill the tank with clean water and circulate through the pump, lines, hoses, and nozzles (for knapsack sprayers, spray to waste through the nozzle).

• Drain and repeat the washing procedure twice.

• Dispose of rinsate/rinse water in accordance with STORAGE AND DISPOSAL instructions below.

GENERAL INSTRUCTIONS: FOR USE AS AN INSECTICIDE:

Thorough coverage is essential.

MIXING:

• Slowly add the required amount of product to the water in the spray tank under agitation.

Dilute Spraying:

• Use a sprayer designed for high volumes of water up to the point of run-off, matched to the crop being sprayed.

• Set up and operate the sprayer to achieve even coverage throughout the crop canopy.

• Apply sufficient water to cover the crop to the point of run-off, avoiding excessive run-off.

• Determine water volume based on industry guidelines or expert advice and add the specified amount of product per 100L of water.

• Spray to the point of run-off.

• Adjust spray volume and operation as the crop grows.

Concentrate Spraying:

• Use a sprayer designed for concentrate spraying, matched to the crop being sprayed.

• Set up and operate the sprayer to achieve even coverage throughout the crop canopy using your chosen water volume.

• Determine an appropriate dilute spray volume for the crop canopy.

• Calculate the concentrate mixing rate accordingly.

• Adjust spray volume, product amount, and sprayer operation as the crop grows.

• For further guidance, consult relevant industry guidelines, undergo appropriate training, and follow industry Best Practices.

SOIL APPLICATION:

• In-Furrow: Apply as a band spray to the open furrow at planting, ensuring all spray contacts the bottom, sides, and all soil drawn into the furrow at closure.

• Use a minimum of 20L of water/ha.

• Use the higher rate under extreme population numbers.

BAIT APPLICATION:

• Bran bait: Mix 10mL/kg of bran with sufficient water to give a moist crumb structure. Allow standing for 2-3 hours before application. Gloves should be worn during preparation and application.

• Cracked wheat or cracked sorghum bait: Mix the required volume of TITAN CHLORPYRIFOS 500 and sunflower oil together. Then, add to the wheat or sorghum, mixing thoroughly. Gloves should be worn during preparation and application.

COMPATIBILITY: TITAN CHLORPYRIFOS 500 Termiticide and Insecticide is compatible with a range of herbicides, insecticides, miticides, fungicides, and fertilizers listed in the instructions. However, it is not compatible with certain herbicides, fungicides, and fertilizers listed as incompatible.

Resistance Warning: TITAN Chlorpyrifos 500 Termiticide & Insecticide is a Group 1B insecticide. Insecticide resistance management strategies are necessary to prevent the development of resistant insect populations. Consult local suppliers or TITAN AG representatives for further information.