Cadence ATZ Herbicide
- Manufacturer
- Loveland Products
- Category
- Herbicides
- Registered until
- Registration expired
- Registration number
- Active materials
- acetochlor0 lb/gallon
- atrazine0 lb/gallon
DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling.
Read all Directions for Use carefully before applying.
ANY USE OF THIS PRODUCT IN AN AREA WHERE USE IS PROHIBITED IS A VIOLATION OF FEDERAL LAW. Before using this product, you must consult the Atrazine
Watershed Information Center (AWIC) to determine whether the use of this product is prohibited in your watershed. AWIC can be assessed through [www.atrazine-watershed info] or [1-866-365-3014]. If use of this product is prohibited in your watershed, you may return unopened product to your point of purchase or contact Loveland Products, Inc. for a refund.
Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.
INFORMATION
For use only on field corn, production seed corn, silage corn, sweet corn and popcorn.
Corn in this label refers to all: field corn, production seed corn, silage corn, sweet corn and popcorn.
Cadence* Atz herbicide is a unique combination of the herbicides acetochlor and atrazine plus the antidote or safener, dichlormid. While the acetochlor and atrazine provide weed control, the dichlormid safens corn against herbicide injury. Cadence* Atz may be applied to the surface or incorporated into the top 1-2 inch layer of soil. It is recommended for control alone, or in tank mix combinations, for the weeds listed in the "Target Weeds" section of these use directions. Cadence* Atz controls weeds by interfering with normal germination and seedling development. Cadence* Atz does not control established or germinated weeds present at application.
USE PRECAUTIONS
• Failure to strictly follow label directions may result in exceeding the maximum annual atrazine use rates as stipulated by the Environmental Protection Agency.
• Note: This product contains atrazine and thus may not control weeds that are known or suspected to be triazine resistant. Following many years of continuous use of atrazine and chemically related products, biotypes of some of the weeds listed on this label have been reported which cannot be effectively controlled by atrazine and related herbicides. Where this is known or suspected and weeds controlled by atrazine are expected to be present along with resistant biotypes, it is recommended that atrazine be used in combinations or in sequence with other registered herbicides which are not triazines. If only resistant biotypes are expected to be present, use a registered non-triazine herbicide.
• Do not use Cadence* Atz on any crop other than field corn, production seed corn, silage corn, sweet corn and popcorn.
• Cadence* Atz should not be used on corn seed stock such as Breeders, Foundation, or Increase.
• Do not contaminate irrigation water used for crops other than corn or water used for domestic purposes.
• Do not apply Cadence* Atz before pre-irrigation in irrigated areas.
• Do not allow Cadence* Atz to contaminate feed or food.
• Cadence* Atz should not be stored near seeds, fertilizers, or foodstuffs.
• All containers of Cadence* Atz should be kept tightly closed when not in use.
• Applied according to directions and under normal growing conditions, Cadence* Atzwill not harm the treated crop. During germination and early stages of growth, extended periods of unusually cold and wet or hot and dry weather, insect or plant disease attack, carryover pesticide residues, the use of certain soil applied systemic insecticides, improperly placed fertilizers or soil insecticides may create abnormal conditions that weaken crop seedlings. Cadence* Atz used under these abnormal conditions could result in crop injury.
Registered for cultures |
---|
Corn |