F9318Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
Restricted Use Pesticide
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. F9318 insecticide/miticide is an emulsifiable in water formulation with two modes of action. F9318 insecticide/miticide will control insect and mite pests on the crops listed within this label when applied according to the Directions of Use unless otherwise directed by registered supplemental labeling. Thorough coverage is essential for good insect and mite control. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation. Rate of application is variable according to the pest. Use lower rates under light to moderate infestations; higher rates under heavy insect pressure. Arid climates generally require higher rates.

Chemigation:
Do not apply through any type of irrigation system.

Adjuvants:
The use of a spray adjuvant that meets or exceeds CDPA Adjuvant Certification is recommended for optimum performance. Refer to the individual crop recommendation sections of this label for specific adjuvant type and use rates. Do not use binder or sticker type adjuvants..

Resistance Management:
F9318 insecticide/miticide contains Group 3 and Group 6 insecticides. Combining insecticides with different modes of action is a resistance management strategy. Because the development of resistance cannot be predicted, the use of this product should conform to resistance management strategies established for the use area. Consult your local or state agricultural authorities for details.
If resistance to this product develops in your area, this product, or other products with similar modes of action, this product may not provide adequate control. If poor performance cannot be attributed to improper application or extreme weather conditions, a resistant strain of insect may be present. If you experience difficulty with control and resistance is a reasonable cause, immediately consult your local company representative or agricultural advisor for the best alternative method of control for your area. More than 2 consecutive applications of F9318 or any products containing avermectin or a pyrethroid is not recommended. For crops that have zeta-cypermethrin and avermectin tolerances the plant back is immediate. All other crops may be rotated 30 days following the final application.