First 1.6 FPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
It is a violation of Federal Law to use this product in a manner inconsistent with its labeling

APPLICATION INSTRUCTIONS
Do not apply First 1.6 F Insecticide in enclosed structures such as greenhouses or planthouses.
Apply First 1.6 F Insecticide as a directed or broadcast foliar spray, with properly calibrated ground or aerial application equipment. For best results, ensure that foliage is thoroughly covered without runoff. To obtain thorough coverage, always use adequate spray volumes, correctly calibrated application equipment, and spray adjuvant if necessary. Inadequate coverage of leaves and fruit may result in poor control or may delay the onset of activity.
Unless otherwise recommended in crop-specific directions, minimum spray volumes are 10 gallons/A by ground, and 5 gallons/A by air. First 1.6 F Insecticide may be applied by overhead chemigation if allowed in crop-specific directions (see CHEMIGATION DIRECTIONS FOR USE, below).
Unless allowed by state- specific 24 (c) supplemental labeling, the use of First 1.6 F Insecticide on crops grown for production of true seed intended for private or commercial planting is generally not recommended. Additional information on First 1.6 F Insecticide for use on these crops and other questions may be obtained from the Cooperative Extension Service, PCAs, consults, or local United Phosphorus, Inc. representatives. Do not apply more than 0.50 Ibs. active ingredient per acre, per year, regardless of formulation or method of application, unless specified within a crop-specific applications section for a given crop.

MIXING INSTRUCTIONS
To prepare the application mixture, first add a portion of the required amount of water to the tank and then add First 1.6 F Insecticide while agitation is underway. Add the remainder of water needed. Agitate during both mixing and application. First 1.6 F Insecticide may also be used with other pesticides and/or fertilizer solutions. Please see compatibility note below. When tank mixtures of First 1.6 F Insecticide and other pesticides are involved, prepare the tank mixture as recommended above and follow suggested Mixing Order below.

Mixing Order
When making pesticide mixtures, add First 1.6 F Insecticide and other wettable powders or wettable granules first, followed by flowable (suspension concentrate) products, then emulsifiable concentrates last. Agitate as each ingredient is added.. Do not add an ingredient until the previous one is thoroughly mixed. If a fertilizer solution is added, a fertilizer/pesticide compatibility agent may be needed. To ensure a uniform spray mixture, continuous agitation is necessary during both mixing and application.

Compatibility Note
Test the compatibility of any intended mixture before adding First 1.6 F Insecticide to the spray or mix tank. To do this, add proportionate amounts of each ingredient in the appropriate order, to a suitable size jar, cap, shake the mixture for 5 minutes, and let set for 5 minutes. If the mixing is poor, or there is formation of precipitates that do not readily redisperse, then the blend is incompatible and should not be used. For further information, contact your local United Phosphorus, Inc. representative.