Nuprid 1.6 F Insecticide

Manufacturer
NUFARM
Category
Insecticides
Registered until
N/A
Registration number
228-488
Active materials
Links

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in any manner inconsistent with its labeling.
DO NOT apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

APPLICATION INSTRUCTIONS
Apply as a directed or broadcast foliar spray. Thorough coverage of foliage is necessary without runoff for optimum insecticidal efficacy. Use adequate spray volumes, properly calibrated application equipment and spray adjuvant if necessary to obtain thorough coverage. Failure to provide adequate coverage and retention of this product on leaves and fruit may result in loss of insect control or delay in onset of activity. Apply this product with properly calibrated ground or aerial application equipment. Minimum recommended spray volumes, unless otherwise specified on crop specific application instructions sections, are 1 0 gallons/Acre by ground applications and 5 gallons/Acre through aerial equipment.
This product may also be applied by overhead chemigation (see additional CHEMIGATION DIRECTIONS FOR USE section below) if allowed in crop specific application instruction section. Use of this product on crops grown for production of true seed intended for private or commercial planting is not permitted unless allowed under state specific 24 (c) labeling. Additional information on this product uses for these crops and other questions may be obtained from the Cooperative Extension Service, PCAs, or local Nufarm representatives. Pre-mix with water or other appropriate diluent prior to application. Keep this product and water suspension agitated to avoid settling.
DO NOT apply more than 0.5 Ibs active ingredient per acre, per year, regardless of formulation or method of application, unless specified within a crop-specific, Application Instructions section for a given crop.

Mixing instructions
To prepare the application mixture, add a portion of the required amount of water to the tank and then with agitation add this
product. Complete filling tank with balance of water needed. Maintain sufficient agitation during both mixing and
application. This product may also be used with other pesticides and/or fertilizer solutions. Please see Compatibility
Note below. When tank mixtures of this product and other pesticides are involved, prepare the tank mixture as specified
above and follow suggested Mixing Order below.

Mixing Order
When pesticide mixtures are needed, add wettable powders first, then this product and other flowable (suspension concentrate) products second, and emulsifiable concentrates last. Ensure good agitation as each component is added. DO NOT add an additional component until the previous is thoroughly mixed. If a fertilizer solution is added, a fertilizer/pesticide compatibility agent may be needed. Maintain constant agitation during both mixing and application to ensure uniformity of spray mixture.

Compatibility Note
Test compatibility of the intended mixture before adding this product to the spray or mix tank. Add proportionate amounts of each ingredient in the appropriate order, to a pint or quart jar, cap, shake for 5 minutes, and let set for 5 minutes. Poor mixing or formation of precipitates that do not readily redisperse indicates an incompatible mixture that should, not be used. For further information, contact your local Nufarm representative. 

Registered for cultures
Cotton
Potatoes
Soybeans
Tobacco
Okra
Eggplant
Peppers
Tomatoes
Artichokes
Broccoli
Brussels sprouts
Cabbages
Cauliflower
Kale
Kohlrabi
Beans
Strawberries
Bananas
Citrus
Coffee
Grapes
Hops