Surflan 0.25 A.S.

United Phosphorus
Registered until
Registration number
Active materials

Directions for Use
It is a violation of Federal law to use this product in a manner inconsistent with its labeling.
Read all directions for use carefully before applying.
Not for use on plants grown for sale or other commercial use, or for commercial seed production, or for research purposes. For use on plants intended for aesthetic purposes or climatic modification and being grown in interior plantscapes, ornamental gardens or parks, or on golf courses or lawns and grounds.
Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application.

General Information
Surflan 0.25 A.S. is a preemergence surface-applied herbicide for the control of annual grasses and many broadleaf weeds.
Soil Preparation: Surflan 0.25 A.S. will not control established weeds. Therefore, areas to be treated should be free of established weeds. Weed residues, prunings and trash should be thoroughly mixed into the soil or removed prior to treatment. The soil should be in good tilth and free of clods at the time of application.
Application Restrictions:
• Keep all persons, children, and pets out of treated area until sprays have dried.
• Do not graze or feed forage from treated areas to livestock.
• Do not aerially apply this product.
• Chemigation: Do not apply this product through any type of irrigation system.

Mixing Directions
Start with a clean spray tank. Fill sprayer one-third (Vs) to one-half (1/2) full with clean water. Start agitation. Add correct quantity of Surflan 0.25 A.S., continue agitation and finish filling the tank. Maintain agitation from mixing through application.
If you see a buildup of material on the walls of the spray tank, wash the tank with soapy water between fillings. Rinse and continue the spraying operation. Clean the tank, lines, and screens thoroughly after use.

Ground Application: Apply Surflan 0.25 A.S. as a directed spray to the soil surface or as an overtop spray. Apply Surflan 0.25 A.S. in sufficient water per acre to uniformly treat the area. Use only a properly calibrated, low-pressure herbicide sprayer that will apply the spray uniformly. Use herbicide tips and screens no finer than 50 mesh in nozzle and in-line strainers. As the amount of water used (spray volume) decreases, the importance of accurate calibration and uniform application increases. Check the sprayer daily to ensure proper calibration and uniform application. Maintain agitation from mixing through application. Avoid boom overlaps that will increase rates above those recommended.

Registered for cultures